The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Gunslinger
« on: April 26, 2012, 05:19:26 PM »

My name is Todd, and I'm a jeep aholic..... Welcome Pilot!  We're all pullin for ya !
Todd
Posted by: CJPilot
« on: April 26, 2012, 03:06:13 PM »

Carlsjeep - It looks better in pictures than it does in person. �I'm working on the title. �The last couple Bill Of Sales had the wrong manufacture date so I�m going down a road I�ll most likely end up regretting by trying to get a title with the correct date on it. �We�ll see. �

It ran real bad but I have figured the timing out. .Somebody put the �distributor in 180 degrees from normal, then somebody put new wires on and must have tried for a long time to get it to run right. �They ended up with the firing order 1234 but with the wires one hole off on the cap. �It ran on 2 cylinders . 2 and 3 if I remember right. �

I�m on to the carburetor now, which had about half an ounce of water in it. How it ran at all is a mystery to me

Steve
Posted by: Carls_jeep
« on: April 26, 2012, 09:24:44 AM »

Hi CJPilot, I saw the photo's of your Jeep on the CJ2 site and it looks ok to me. If your going to use it for fun don't go over board on restoration. Do what is needed to make it safe and mechanically solid and any body work you feel is needed. If you have a title get it registered so you can take it on the road if you want to. If you don't have a title you probably can get one depending on your state laws. Sometimes it takes a little work but you probably can get it titled.
Posted by: athawk11
« on: April 25, 2012, 11:01:22 PM »

Hi Steve.
Welcome to the site. �And thank you for rescuing another old, beautiful Willys Jeep. �It is very frustrating at times, but incredibly rewarding to breath life back into an American Icon.

If you poke around, you know how much people here like photos and any data you can share about your Willys. �I will ask: �What is the serial number on your data plate?

To post pictures, you will need to first post them at a site like www.Photobucket.com �It is a free photo hosting site. � Read through the posts in the below link. �It may help you with the process.

http://cj-3a.com/forum/YaBB.pl?num=1296834876  If this post doesn't help I'll try to give you some step by step instructions.

Once again, �welcome. �You won't find a better bunch of folks with incredible levels of knowledge.

Tim
Posted by: CJPilot
« on: April 25, 2012, 09:40:34 PM »

Hi. I�ve been lurking here a bit and I ended up buying a 1950 CJ3A the other day. �It kinda sorta runs and drives, but not very good. �I'm going to start fixing up the obvious and try and get it to the point of being able to use it in back of my property. �The body is rough and will need to be addressed later. �I tried posting a picture but had zero luck.

Steve