The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: F Bill
« on: April 23, 2012, 11:34:20 PM »

Quote
I am about to start my L134 for the first time since it was overhauled in 2004. I am planning on using a grease gun which has been cleaned and screw the gun hose 1/8 in. pipe thread into the oil pressure guage outlet. Then I would pump engine oil into the oil system. I think I can put all 4 quatrs in this way if necessary but it probably isn't. How about some feedback to see if I am on the right track and not getting ready to harm the engine. Thanks.

That is the best idea I have heard all day! (If your grease gun works with oil) .........I just might steal that one.
Posted by: Gunslinger
« on: April 23, 2012, 11:18:33 PM »

When I did mine we put assembly lube in the oil pump, just packed her full, then filled the oil reservoir, left the switch off pulled the spark plugs out and turned the engine over until pressure came up on the gage, then we started it.  I've never done one that sat as long as yours has, that may be different.  I have heard that assembly lube will lube the engine for 3-5 minutes with out oil flow, but I wouldnt trust that any of that is left in those old rebuilds.  Injecting it might be a pretty good idea.
Posted by: Shalka04
« on: April 23, 2012, 10:23:27 PM »

I'm in the same boat so to speak, except my rebuild hasn't been started since it was put together in 1990.  I like your idea but was also thinking of getting some oil onto the valves via the pcv opening on the valve cover.
Posted by: Bob W
« on: April 23, 2012, 08:54:12 PM »

Sounds like a good plan to me.
Posted by: Macgraham
« on: April 23, 2012, 08:49:14 PM »

I am about to start my L134 for the first time since it was overhauled in 2004. I am planning on using a grease gun which has been cleaned and screw the gun hose 1/8 in. pipe thread into the oil pressure guage outlet. Then I would pump engine oil into the oil system. I think I can put all 4 quatrs in this way if necessary but it probably isn't. How about some feedback to see if I am on the right track and not getting ready to harm the engine. Thanks.