The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: April 15, 2012, 10:56:48 PM »

Yes, we're both saying the same thing.
Posted by: Gunslinger
« on: April 15, 2012, 06:15:21 PM »

Hey Carl, what I was sayin was to remove all the other stuff, put the wiring back together as defined in the manual, and use a coil with the proper resistor built in.  That way all the voltages are correct at the right locations.
Posted by: Carls_jeep
« on: April 15, 2012, 02:46:49 PM »

It sounds like your coil has the resistor built into the coil. Adding another resistor would make the spark very weak.
Posted by: Gunslinger
« on: April 15, 2012, 09:55:08 AM »

By the sounds of it you maybe converted the jeep to 12 volts from 6?  I did the same thing, but was able to buy a coil from NAPA that has the resistor built in, that way I was able to keep the wiring all according to the manual.
Posted by: CJJay
« on: April 15, 2012, 12:00:25 AM »

Forgot to ask about the in line resistor. The only way to getit to run was to by pass the one resistor I had from several years ago. It did seem to work on my truck and it won't work on this cj so h do I get a correct resistor to put in line with the coil to not burn out my points.