The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Macgraham
« on: February 21, 2012, 10:36:41 PM »

I took a socket which fit into the tube snugly and held it in the vise and worked the tube on and off and sideways and it made a good snug fit with the block. It worked out real well. thanks for you're help.
Posted by: Jesse
« on: February 21, 2012, 10:04:40 PM »

I took a rounded over punch and put a few indents from the inside out on the bottom edge. Not huge dents, just 3 or 4 small ones for a tight fit. I was able to tap it in with a block of wood on the top and it is holding fine.

-Jesse
Posted by: turkehunt
« on: February 19, 2012, 04:00:14 PM »

I have the same problem with no clamp @ the top The permatex 2 Sounds good  :)
Posted by: p3ferris
« on: February 09, 2012, 09:33:14 PM »

Just push it down and fasten the clamp tight.
Posted by: athawk11
« on: February 09, 2012, 02:33:08 PM »

Mac,

I used Permatex 2.  It's a plyable, non hardening seal.  Worked fine.  I also used it on my spines at the transfer case, and to seal threads on the bolts.

Tim

Posted by: Macgraham
« on: February 09, 2012, 01:05:02 PM »

Just getting engine ready to install, the dipstick tube seems to be fairly loose fit. Is there a way to seal it since there is no place for an o-ring? It came from another 134 so I thought it would be ok. Any suggestions?