The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: athawk11
« on: February 02, 2012, 09:41:51 AM »

I think it's just to keep the dust off the oil that leaks through the seal. ;D �Just a little leaky humor there.

Tim
Posted by: Comanche_County
« on: February 02, 2012, 04:31:54 AM »

Ooh, thanks for that link, just when I thought I'd already squeezed the Novak site for all it was worth.  I missed that one.  

But I don't see how the felt even helps at all???? :-/
Posted by: athawk11
« on: February 01, 2012, 09:39:46 PM »

Hey Comanche,

I got my DANA 18 seal kit from Walcks. �It had all the seals and gaskets, was reasonably priced and they fit as they should.

I used Permatex "2" on the splines, on the output yoke (front) and the companion flange (rear).
 ï¿½
I put the new felt seal where I found my old one. It goes on the output companion flange. This is the part that has the splines and ultimately is attached to the propeller shaft. � On the front output yoke, there is a protective cup that has a internal ridge that the felt seal sits in. �I think the felt seal acts more like a dust seal than an oil seal.
Here is a link that was very helpful to me.

http://www.novak-adapt.com/knowledge/dana_18_rebuild_guide.htm

My hand brake assembly was full of crud when I took it apart. �So far, it's about the only thing I sealed that hasn't sprung a leak.

Tim � �
Posted by: Comanche_County
« on: February 01, 2012, 05:15:03 PM »

I'm putting the D18 back together and I'm really not thrilled with the oil seals that came with the kit I bought.  The shift rod seals were just a little too big and I warped them into a slight concave shape to get them in.  The larger input and output shaft oil seals fit perfect, but the little single lipped seal just seems insufficient to me.

I understand some leakage is normal with a D18 ("all Jeeps mark their spot") and I'm keeping the original open bearings vs going to a seal bearing.  I'd like to get it sealed up nice and tight (if at all possible) while I've got it out.  

What are the best seals to use?

Where else should I be concerned with?  I've read about leaks ruining the E brake and a possible fix is pipe sealer on the yoke splines and four mounting bolts.  What do you guys recommend there?

I Also, this may be a dumb question but where exactly do the felt seals go?  My D18 didn't have them.  I'm guessing behind the oil seals next to the bearing?

Thanks fellas.