Posted by: athawk11
« on: January 24, 2012, 12:48:21 PM »Ventport,
Cool idea. I was lucky enought to have new NDCC tires. The mold line down the center is still very visable.
Carl, thank you for the detailed explanation. I appreciate it. As you said, the most difficult and time consuming issue I had was making sure the steering box, thus the wheels, were aligned straight forward. Constant measuring between the back and front of the tires, a string from rear tires to fronts, and an aluminum straight edge... rolling the Jeep forward, measuring again, then doing it all over numorous times to make sure all was dead straight.
My toe in measurement kept coming out the same. 7/8", with more toe in on the driver side... I adjusted both wheels to '0' toe in, then set identical toe in on each side.
I can only speculate, but I think the PO wasn't as causious and careful the last time toe in was done.
Thanks again.
Tim
Cool idea. I was lucky enought to have new NDCC tires. The mold line down the center is still very visable.
Carl, thank you for the detailed explanation. I appreciate it. As you said, the most difficult and time consuming issue I had was making sure the steering box, thus the wheels, were aligned straight forward. Constant measuring between the back and front of the tires, a string from rear tires to fronts, and an aluminum straight edge... rolling the Jeep forward, measuring again, then doing it all over numorous times to make sure all was dead straight.
My toe in measurement kept coming out the same. 7/8", with more toe in on the driver side... I adjusted both wheels to '0' toe in, then set identical toe in on each side.
I can only speculate, but I think the PO wasn't as causious and careful the last time toe in was done.
Thanks again.
Tim
