The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: RussellL
« on: July 14, 2011, 02:17:54 AM »

I would say that so long as the e-brake is not dragging when the handle is all the way in, you are good to go.  
Posted by: Gunslinger
« on: July 13, 2011, 09:12:22 PM »

Larry,
When the Ebrake is adjusted correctly, how much pull would you see on the cane style handle?  I pull mine about 2 inches and the brake is locked up is that not enough?  Maybe the question is how much play should be in the cable?
Posted by: rocketeer
« on: July 03, 2011, 06:59:30 AM »

There's a clip on the side of the bell housing and a clamp on the passenger side of the crossmember.





Larry
Posted by: RandyA
« on: July 03, 2011, 01:26:16 AM »

can someone tell me where the bottom clip on e brake cable anchors too ,near the actuating arm?? mine was awol at time of purchase and cannot find big hole...little hole anywhere near brake...ran cable out of firewall along stb side of block, then??? thanks as always..