The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: jamesr
« on: December 29, 2010, 09:22:31 AM »

try soaking it with PB Blaster. Jim
Posted by: mrman5917
« on: December 28, 2010, 10:26:17 PM »

Hello everyone,

I started the tear down of my CJ-3A in preparation for restoration this past weekend. As I was working on removing the front lights, the headlights came out nice and easy. Then I moved on to the parking lights. After removing the lens, retaining ring, and what I can only guess used to be some sort of seal, I was down to just a bare bulb on the front and the socket on the rear of the grille.

I started trying to twist and pull but was unable to get much movement in any direction. Based on the remainder of the seal, what was left of the original cloth wiring harness, the amount of rust on the bolts and the apparent corrosion around the socket, I'd venture to guess it's never been touched in 60 years or at least not very recently.

So, on the fear of sounding like an idiot, how can I remove the parking light assembly from the grill without breaking the bulb and implanting some very old glass into my finger?