I had to break it up a bit, it is getting long.So you have seats, windshield� and top stashed away.
Next, before we get to far, it might be nice to drain the fluids...Sure makes keeping your floor clean easier, especially if you are the sort of guy that uses a drain pan to empty them into instead of the ground...

THE block has a drain as well as the radiator, and that will make things a little dryer� compared to just draining the radiator. Recycle appropriately. Used oil sometimes gets saved for my chainsaws (Yup, they are cheapie Poulans, not Stihls that take nice bottled chainlube) and antifreeze gets saved so I can decant off the clean stuff and use it in whatever I am driving that has some coolant leaks like my tractor... If you don't save it for later, the fluids usually can be dropped off at places like Oreillys� or Auto Zone.
The gas tank is another part that should be pulled fairly early on. Keep flames away...and store it in a safe place where sparks and small children can't get near it.� If you have an oldtime radiator shop� you use, might want to bring it down to see what they think of it. If it is obvious junk, save it to keep your sender in for now..and to match it up with the new tank from Walcks.
IF you are doing a frame off complete restoration, the body parts are next. Grille and radiator, hood, and front fenders all get pulled and put in a safe place. A sheet of cardboard or thin plywood on both sides of that valuable radiator can prevent tragedies from happening in storage. Fenders can nest in each other to store, and fit well in the attic or rafters of your garage with the hood.
You've put it off long enough, time for the Steering Wheel. It is so dastardly we even have our own section on pulling the steering wheel, as do most jeep sites. A proper puller, protection for the fragile threaded area while using it, and safe procedures are mandatory. DO NOT try to pull it off by hand unless you hace the nut still loosely on the shaft, as dental work will ensue otherwise.
You can also pup off the steering gear from the frame now.� (For those of us with column shift, you'll have to remove the shift rods too..)Withdraw it downward and forward, you might have to have the left front wheel off and the front end in the air to do it.
Next is the tub....be prepared for battle with all the attaching bolts, and don't forget to disconnect the wiring where needed..