The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: athawk11
« on: December 14, 2015, 06:07:24 PM »

Hi Dave,

Check to make sure you have the transmission shift fork in the 1st/Reverse gear slot.

Tim
Posted by: DaveL
« on: December 14, 2015, 03:56:46 PM »

Have installed main drive gear -  transmission seems locked in Rev.  In Rev gear it backs up -  in 1st gear it backs up  -  in 2nd and 3rd when you release clutch, engine stalls out
Posted by: DaveL
« on: December 01, 2015, 09:58:15 PM »

Removed overdrive today. Found overdrive shift yoke broken inside . have located main drive gear and will install to ensure transmission is OK, while overdrive is overhauled. Will post results.  Thanks
Posted by: bretto
« on: November 28, 2015, 09:12:15 AM »

Do you know the history of that overdrive? How long have you own the Jeep?  Some of the early Saturn OD we're know to have the shift forks break.  Seems odd that it would hold out this long and happen now though.
If you're certain the tranfer case is not in neutral and the throw on all the linkages are all good, then yes, I'd pull the OD out and start there.  Do you have the stock output gear for the t-case that the OD replaces just in case the OD is out of commission?
Keep us in the loop.  Follow up post are eternally helpful to everyone in the future that may come along.
Brett
Posted by: DaveL
« on: November 28, 2015, 01:51:13 AM »

yes, I've ne from low to high in all gears and am pretty sure the transfer is engaged
Posted by: athawk11
« on: November 28, 2015, 12:45:51 AM »

Are you sure he didn't accidentally shift the transfer case in to neutral?
Posted by: DaveL
« on: November 27, 2015, 11:06:30 PM »

my son's 58 3b is having problems. he was shifting out of overdrive and now is not getting anything. No forward or reverse gears.
checked linkage and everything seems to be working. no grinding noises. Was running fine now nothing. should i start by removing overdrive ?