The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: mtnman37879
« on: May 13, 2019, 08:48:42 PM »

The tool needed is a bushing driver. It will safely drive out and re install the new ones.

https://www.toolsid.com/oem-tools/bushing-driver-set-mpn-27137.html?view=408724&gclid=CjwKCAjwq-TmBRBdEiwAaO1enzKRjwEzRtrNTy3w8OSSqWbTji5E3lpQM5JCmMKUuP_ob64PJWEjvxoC7wYQAvD_BwE
Posted by: Andrew
« on: May 12, 2019, 03:37:20 PM »

What method has proven acceptable for removing worn distributor shaft bushings and installing new ones? The service manual just says to replace them if worn but without any clue as to how to get them out and in. Any 'been there,done that' suggestions will be appreciated. Distributor is the standard AutoLite IAD-4008A. Thank you