The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: Distributor Bushings replacement  (Read 1229 times)

0 Members and 1 Guest are viewing this topic.

Offline Andrew

  • Project Jeep (Newbie)
  • *
  • Posts: 14
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Distributor Bushings replacement
« on: May 12, 2019, 03:37:20 PM »
What method has proven acceptable for removing worn distributor shaft bushings and installing new ones? The service manual just says to replace them if worn but without any clue as to how to get them out and in. Any 'been there,done that' suggestions will be appreciated. Distributor is the standard AutoLite IAD-4008A. Thank you
Logged

Offline mtnman37879

  • Flatfender Enthusiast
  • ***
  • Posts: 174
  • Karma: +0/-0
  • Plays With Jeeps
    • View Profile
Re: Distributor Bushings replacement
« Reply #1 on: May 13, 2019, 08:48:42 PM »
Logged
People think I go out of my way to * them off.
Trust me, It's not out of my way at all.
Pages: [1]   Go Up
« previous next »