Posted by: aboyandhisdog
« on: October 22, 2018, 09:08:05 PM »
Well, I finally got around to scraping my old screw on oil filter and replacing with the "correct" style Fram from Walcks.� I put the usual 4.5 qts. in the crankcase and a half quart in the filter, which brought the level in the canister to about half way.� When I put the filter inside the oil came to about 3/4 of the canister.�
So I thought I had it all handled.� My new hoses didn't leak which was my fear originally.� But, when I took a nice long drive, once the engine was nice and hot, the canister lid leaked oil down the sides which then blew all over the engine compartment!� Huge mess!
So, what the heck did I do wrong?� I had the lid nice and tight, but did find that I could tighten it a bit more after the melt down.� The gasket was in place under the lid.� Did I overfill the canister?� Is my oil pressure too high?� (the high is generally 40-50psi)� I don't think my lines are blocked as the oil in the filter is now dark so I feel it must be circulating well.�
Tomorrow I will siphon some oil out of the filter to bring down the level to say, 1/4 full.� Has this ever happened to others?� What say you?
I happen to have a spare filter on hand and opened the box to look at it. There is the gasket for under the lid, and there is also a o-ring in the box. Where does the o-ring go? I can't find one on the filter that came in the canister.