The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: athawk11
« on: March 27, 2018, 09:43:39 PM »

Very cool design.  I like it!
Posted by: Tumbleweed
« on: March 27, 2018, 08:33:15 AM »

Looks great!

Tumbleweed..........
Posted by: Gunslinger
« on: March 26, 2018, 05:35:44 PM »

Last one, any questions let me know.  In case anyone asks, GFT is Gun Flint Tavern, its a cool place to ride, the Gun flint Trail, and the tavern is OK too.
Posted by: Gunslinger
« on: March 26, 2018, 05:15:19 PM »

I know this looks like I'm jacking my postings up to get more of those little stars... it seems like the long way around the barn but If I don't have to use PB anymore I'm happy !

This is how I attached the carrier to the jeep, on the top I used the tailgate hooks attachment, on the bottom I bolted it to a couple of holes in the rear cross member.� These holes are located pretty close to the draw bar mount location.
Posted by: Gunslinger
« on: March 26, 2018, 04:56:53 PM »

Here you can see where I attached the can carrier and tire mount, I used the same tire carrier that was on the the side and bolted it to the carrier.
Posted by: Gunslinger
« on: March 26, 2018, 04:53:03 PM »

Below are a number of photos:
First the completed carrier with can and tire.
Posted by: 64CJ5
« on: March 25, 2018, 10:57:11 PM »

I built a carrier to hold three gerry cans in 1973 for our new CJ5.  The carrier has been on three Jeeps and is now configured for one can, a high lift jack and the spare tire.
I think you will enjoy your creation for years.
Hope to see pictures.      
Posted by: Gunslinger
« on: March 25, 2018, 10:43:39 AM »

Guys,
I finally got a round to building that tire/can carrier that I've been putting off.� I used Jpets basic design, but used 1.5x1.5. x1/8 steel tubing instead of angle.� I used the tail gate hooks as the top point and the rear cross member as the lower point instead of the drawbar.� Now, If one of you guys can help me with how to get those photos out of Photo bucket and onto this page I'll post some photos.� I think it looks pretty good, a local painter powder painted it for me.
Thanks for the help