The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Ryan_M
« on: October 27, 2016, 09:14:34 PM »

[media]https://youtu.be/teZJN2eXz1g[/media]
Posted by: CJTHREEA
« on: October 16, 2016, 04:12:34 PM »

Thank you Hawk!

I'm thinking mine are getting around 120/130 as well.

Is starting position towards drivers side or passenger side?

I have a 2A but it has a 3A windshield so I figured it more appropriate to post here.

After looking at the size of the arms and blades I had the wrong ones too as I've seen the 3A windshields blades are 9" - just not sure if my arms are wrong too - I'll have to look for a model number or something on them.
Posted by: Oilleaker1
« on: October 14, 2016, 09:14:52 PM »

 Some arms can be adjusted to sit flat on the lower windshield rubber which will give you more range. 3A or M38, not 2A. John
Posted by: athawk11
« on: October 14, 2016, 01:34:10 PM »

CJTHREEA,
I don't know the actual range of motion, but 120-130� is about all you want. 

Assuming they are positioned in the stock location, when 'parked' at 0�, the top of the wiper comes pretty close to the edge of the windshield when reaching the degrees mentioned above.

I can measure the angle tonight if you want it, but my motors are SF-616...The standard issue for the CJ3A.

Hawk
Posted by: CJTHREEA
« on: October 13, 2016, 11:39:47 PM »

Does anyone know what the range of motion degrees should be?

My wiper motors are wiping through at least 120 degrees of motion...

Granted I have M131 motors but I understand these should work .... :o