The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:

Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: 1955CJ-5
« on: January 23, 2014, 09:28:55 PM »

That could be it...I can visualize that jeep bouncing over uneven ground with some heavy mower pulverizing the vegetation...

The PTO drive shaft has dents where it hit the axle...

Posted by: SteveW
« on: January 23, 2014, 03:37:23 PM »

There were bush hog mowers that attached to drawbar
Posted by: Quebec Jeep
« on: January 23, 2014, 02:08:01 PM »

I don't see any reason why we would bent leaf spring like that but who knows.

I guess overweight on the rear is the reason. The two last leaf are not attached so they didn't bent back.
Posted by: 1955CJ-5
« on: January 23, 2014, 11:01:13 AM »

Wasn't there a pull behind type, or one that mounted on the drawbar?


Posted by: Quebec Jeep
« on: January 23, 2014, 09:10:44 AM »

A mowing machine....rear spring bent...

Like this?

http://www.film.queensu.ca/CJ3B/Tech/KandKMower.html
Posted by: johnrb3b
« on: January 23, 2014, 09:01:02 AM »

Quote
The bottom two leaves of both rear spring packs were bent over backwards....
Wow, I'd like to see a picture of that.
 :D
Posted by: 1955CJ-5
« on: January 22, 2014, 09:01:19 PM »

Maybe. That is sort of what I was thinking..

This had a rear PTO...the previous owner thought he remembered a mowing machine....


The bottom two leaves of both rear spring packs were bent over backwards....
Posted by: p3ferris
« on: January 22, 2014, 08:29:14 PM »

Jeep a trench set up maybe
Posted by: 1955CJ-5
« on: January 22, 2014, 07:17:57 PM »

My 3a came to me with an aluminum half cab. Someone along the way added a heavy board that was mounted vertically between the wheelhouses and which protected the rear panel of the cab.

I pulled this off months ago and today I moved it and happened to notice that the "brackets" they used to mount it were actually placards that had been cut in half..

The Osgood company made heavy equipment....this may be a clue to why my rear springs were bent over backwards!

Any ideas?