The CJ3A Page CJ3B.info

Post reply

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

Name:
Email:
Subject:
Message icon:
Verification:
Type the letters shown in the picture
Listen to the letters / Request another image

Type the letters shown in the picture:
Write the word between words Jeep from this JeepWILLYSJeep?:
How many slot has a GPW grill?  7 - 9 - 11:

shortcuts: hit alt+s to submit/post or alt+p to preview


Topic Summary

Posted by: Carls_jeep
« on: November 28, 2011, 10:23:24 PM »

When I get it from Bob I'll make a drawing and email it to you. What I'll do is make a template of the part without the bends and a side view showing the bends. That way you can have a blank sheared or burned out and then have it bent.

Do you want a template of my flat hitch plate? With both you would have three different heights for the ball.
Posted by: Gunslinger
« on: November 28, 2011, 08:49:03 PM »

Can one of you guys take a photo or get som dims on that part?  I need one as well and can get one made if I have some direction.
Thanks
Posted by: Carls_jeep
« on: November 27, 2011, 08:13:49 PM »

I'll take it, I can weld and re-drill the hole, no problem. You still have my address and email don't you? Let me know the shipping cost and I'll send the money.

I just went and gave mine a close look see and it is home made. It is torch cut and a real good job at that. So good I never gave it a second look.

The CJ2A parts Jeep I have has a Rube Goldberg hitch on it.
Posted by: Bob W
« on: November 27, 2011, 07:49:03 PM »

Only the very very early Jeeps had flat hitch plates. Can't really tell from the photo but I suspect yours was fabricated by a previous owner. I've got a "normal" offset plate you can have. The hole is kinda egg shaped from running with a loose ball.
Posted by: Carls_jeep
« on: November 27, 2011, 11:33:10 AM »

I just noticed something I have wondered about but forgot to ask. My Jeep has a hitch plate that is straight. You can see it in my thread about license plates. Calvins Jeep has a stepped plate, that is it has two bends in it so it can be put on with the ball high or low.

Now I am wondering is the Jeeps came with two plates. One that can be flipped for a high or low mount and a flat plate for a middle mount.

Does anyone know if this is so and where can I get the bent plate or do I have to make one for myself?