The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: Foot starter  (Read 1683 times)

0 Members and 1 Guest are viewing this topic.

Offline Kenny_Kustom

  • Willys Fan
  • **
  • Posts: 72
  • Karma: +0/-0
  • Too cold outside to play....
    • View Profile
Foot starter
« on: March 20, 2013, 08:32:24 PM »
Is there supposed to be anything around or over the opening in the floor that the foot starter rod comes through?
My hole is a little bigger than it should be i think..
Logged

Offline F Bill

  • Flatfender Master
  • *****
  • Posts: 1402
  • Karma: +1/-0
    • View Profile
Re: Foot starter
« Reply #1 on: March 20, 2013, 08:43:31 PM »
There is a wooden block that screws to the floor. Check Bob W's site for the dimensions....

http://www.cj3a.info/tech/sblock.html

We have some info on our home page links but it is mostly incorrect, especially about where the spring goes..That will get corrected in time.
« Last Edit: March 20, 2013, 09:29:13 PM by F_Bill »
Logged
Owner of the world famous?? Pintojeep 3A and one yet to be named stock project 3A.
Based in central TX and upstate NY.

Offline macrisel

  • Flatfender Master
  • *****
  • Posts: 639
  • Karma: +0/-0
  • Always in the middle of a project
    • View Profile
Re: Foot starter
« Reply #2 on: March 21, 2013, 04:40:02 PM »
My thread below has the block I just built for my foot starter using Bob W's measurments in his book.

http://cj3apage.com/forum-yabb/YaBB.pl?num=1357924352/15#15

I made my block out of composite decking board to avoid rot. �After a coat of paint, you can barely tell its not real wood.
Logged

Offline Kenny_Kustom

  • Willys Fan
  • **
  • Posts: 72
  • Karma: +0/-0
  • Too cold outside to play....
    • View Profile
Re: Foot starter
« Reply #3 on: March 21, 2013, 09:52:52 PM »
This is what I'm dealing with.
Logged

Offline Kenny_Kustom

  • Willys Fan
  • **
  • Posts: 72
  • Karma: +0/-0
  • Too cold outside to play....
    • View Profile
Re: Foot starter
« Reply #4 on: March 21, 2013, 10:26:41 PM »
Im thinking maybe a trim ring from the tcase shifters and a flat piece of rubber?
Logged
Pages: [1]   Go Up
« previous next »