Brett,
�Yes, I have available to me any gauge MIL-Spec wire and any MIL-Spec connectors that may be needed in the aircraft maintenance shop where I used to work. �Many of my previous post have included pics showing my Jeep in the fine shop among the flying machines. �When I made my wiring harness I ordered a 100 ft roll of the wire gauge I was going to use the most (16 gauge I think). �It cost me about $30. �What was left over I traded for the short runs of heavier gauge I needed. �I was able to use most of the bulb sockets and terminals unique to the Jeep harness from my old harness by uncrimping or unsoldering and inserting the new wire. �Now when I was rebuilding Mike's, 44 MB, my friend who lives there in your home-town, we chose to buy a harness from Walck's. �It was a beautiful harness and worked very well. �It was made of the original style cloth braid insulation with color coding woven into the braid. �Sockets and terminals were perfect, but it was expensive. �However, Mike didn't have enough left from his original harness to reuse the bulb sockets and other special terminals needed. (You've got to get over and see his Jeep and his old WWII trainer aircraft we restored before we restored the Jeeps.) �
The military specification MIL-W-22759/16 is required by the Federal Aviation Administration for all wiring used in aircraft. It comes in all gauges. The insulation is not cloth, but per the MIL-Spec is made of polytetrafluoroethylene (PTFE) which provides enhanced mechanical toughness and exceptional resistance to heat, radiation and chemicals. The conductor is made of multiple strands of copper and tin coated.
To answer your curiosity: On an aviation application, unless specifically indicated otherwise per the aircraft manufacturer's maintenance manual, a MIL-Spec connector may be simply be crimped and be considered complete. Most often crimped connections are also soldered. Usually heat shrink is satisfactory but on some applications the connection must be potted (sealed) with MIL-S-8802 potting compound. �This is a two-part self vulcanizing rubber compound. �
On my Jeep harness I crimped and soldered each connection. (Mice won't nibble on it and it won't chafe, so in another 60 years when my Jeep has rusted away the harness will still be as good as new.)
I don't know where you could get cloth bound wire, but if you think you would like some of the aviation stuff I can get it for you at wholesale.