Well, I FINALLY got everything disassembled last night. I had to remove the brand new exhaust I had put on several month ago in order to get the cross shaft out. In my infinate wisdom, I had reeeeeaaaallly torqued the exhaust clamps down to avoid any exhaust leaks. This resulted in a great deal of curse words last night trying to get the (*&#@$(* exhaust split apart!
When I got the cross tube and brake arm out, both of them had wear on them. The cross tube has groves worn in it where the brake arm rides and the brake arm hole has been egged out pretty good also. It appears the pivot tube on the frame has been replaced sometime in the past and does not look too worn. The Bubba that replaced it not only bolted it to the frame, but ran a weld around it AND put a bead of weld on the nuts to keep them from backing out. Genius.... Anyway, I have already sandblasted and painted the frame so I'll probably leave it as it.
I considered only replacing the cross tube and putting a bushing in the brake arm but decided against it. I would have to drill out the brake arm, find a bushing and press it in, drill it out to match the cross tube, then drill the zert fitting in. While I know it can be done, I probably don't have the correct size drill bits and at this point I really don't have the time. A new brake arm from Walcks is $28 and I'll probably go that route. :-/
Like everything else, it always comes down to time and money. Do you ever reach a point in life where you have enough of both? :-?