The CJ3A Page CJ3B.info

Author Topic: PTO Identification  (Read 3024 times)

0 Members and 1 Guest are viewing this topic.

Offline Don

  • Project Jeep (Newbie)
  • *
  • Posts: 15
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
PTO Identification
« on: June 19, 2016, 11:04:04 PM »
All
I have a model 50 PTO, pulled it apart today and verified that it is good internally and buildable.� But after looking at some photos and documentation online I am wondering is this for a CJ, or something like an FC.� Any input would be appreciated.
Don
« Last Edit: June 20, 2016, 09:20:46 AM by johnrb3b »

Offline johnrb3b

  • SMF Administrator
  • Flatfender Master
  • *****
  • Posts: 906
  • Karma: +0/-0
  • No such thing as too many Jeeps - well maybe
    • View Profile
    • Jeeps and stuff
Re: PTO Identification
« Reply #1 on: June 20, 2016, 09:23:55 AM »
It's a front PTO drive.
Probably work with any D-18.
The length from the transfer case hole out to the PTO shaft hole might vary by vehicle - mostly determined by vehicle width, but it's possible they were all the same.

Anybody out there know?
1946 2A - - - 1949 me - older than most of my Jeeps
1954 3B - - - 1957 Wagon - - - 2010 4-door JK
past Jeeps ---> '54 3B - no tub --- '59 3B - no engine
past addiction - VW ---> '69 bus --- '70 camper

Offline Bob W

  • Flatfender Master
  • *****
  • Posts: 2309
  • Karma: +0/-0
    • View Profile
Re: PTO Identification
« Reply #2 on: June 20, 2016, 10:15:58 PM »
Kinda looks like a Model 40 to me. That would be for a wagon or truck. Check out Art's website here...
http://48cj2a.com/PTOs.htm
Bob W

Offline Don

  • Project Jeep (Newbie)
  • *
  • Posts: 15
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: PTO Identification
« Reply #3 on: June 23, 2016, 09:42:02 PM »
Bob, looks like you are correct.  Wont work on the 3A without a lot of work, so perhaps it can help fund the rest of the rebuild.

Anyone have an idea of its value?