The CJ3A Page CJ3B.info
« previous next »
Pages: [1]   Go Down

Author Topic: Swaging rear studs  (Read 1741 times)

0 Members and 1 Guest are viewing this topic.

Offline Rob G

  • Project Jeep (Newbie)
  • *
  • Posts: 7
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Swaging rear studs
« on: April 07, 2019, 07:44:55 PM »
So I have figured out the removal process for removing the studs from the rear hubs/drums... the hard way of course.

My question is; is it necessary to swage the new studs back in?

There is a lot of discussion about removing studs/swage, but nothing about reinstallation that I can find.
Logged
1949 Willys CJ3A

Offline Russell

  • Project Jeep (Newbie)
  • *
  • Posts: 6
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: Swaging rear studs
« Reply #1 on: April 09, 2019, 12:32:22 AM »
 I've replaced broken studs before and they went in the old hole. I tapped mine is with a hammer. Then finished them when I put the tire back on to make sure they seated. In my opinion it worked fine. Just my two cense.
Logged

Offline Rob G

  • Project Jeep (Newbie)
  • *
  • Posts: 7
  • Karma: +0/-0
  • Still Plays With Jeeps
    • View Profile
Re: Swaging rear studs
« Reply #2 on: April 10, 2019, 03:27:04 PM »
Thanks for the input!
Logged
1949 Willys CJ3A
Pages: [1]   Go Up
« previous next »