I do make some assumptions regarding the availability of the adapter bracket/plate.� I have one too.� When folks find out I've got one, they ask (sometimes numerous times) if I want to sell it. I keep it because it's a unique, one purpose bracket.� Plus, it's kind of cool.

I'm sure you're right.� There were probably plenty of them at some point, but because they are a "one purpose" bracket, many may have been discarded, scrapped, forgotten about, etc, over the past 50-60 years.� Many people, in the know, that have these old 2As and 3As do not know this bracket exists or what it's used for.
In the age of the world wide web, and the ease of purchasing Willys parts, I would assume that folks do what I did and purchase the correct 3A style front engine plate, then discard this bracket.
My first 3A had this bracket joining a GPW engine to the 3A frame.� This GPW was most likely an engine that Ford sold to a repair shop following the end of WWII.� There is no GPW serial.� The engine has never gone through a full rebuild.� I ridge reamed, replaced the rings, and re-honed it a few years ago.� Still has the standard size pistons, and the crank mains and piston bearings are still standard size.� Makes me think it sat on the shelf for quite some time before the prior 3A owner came in with a problem.


In any event, keep showing your progress. It really is fun to live precariously through you.� Wish I had your car lift.
Tim� �