There is a retainer washer between two nuts. Sometimes one part of the washer is bent over the outer nut to keep it from coming loose. You have to straighten the washer, remove the outer nut, remove the washer, remove the inner nut then pull the brake drum/hub off the spindle with your hands. The outer bearing will fall out of the hub and the inner bearing is held in place by the grease seal.
Lay the drum on a workbench and with a 1/2" dia. brass drift hit the inner bearing race and the seal and bearing will fall on the table. Wash the bearings in a solvent of choice and remove the grease from the hub and then wash it with a solvent. When everything is clean and grease free inspect the two races in the hub for pitting and the inner races of the inner and outer bearings for pitting.
If everything is good pack the bearings and there is a correct procedure for that. Put a liberal amount of grease in the hub and on the inner race lay the bearing in and drive the seal into the hub. Flip the drum/hub over and put the outer bearing in the hub. Clean the spindle and seal area and put a light coat of grease on the seal area.
PACKING A WHEEL BEARING: Clean your hands, put a dab of grease in the palm of one hand and with the other hand hold the bearing with the wide part facing the grease. Attack the edge of the dab of grease with the edge of the bearing in a manner that forces grease between the inner race and the retainer that holds the rollers in place. It takes a little practice and just using the very edge of the grease dab with repeated swipes and the grease will start coming out on the narrow side of the bearing. When that happens turn the bearing slightly and start on it again until grease comes out. Repeat that until the entire narrow side has grease coming out of it. You have to keep adding a little grease to your palm but don't get to big a dab or you will have a lot of trouble.
A LITTLE DAB'L DO IT. BRILL CREAM I just couldn't resist.

THE BEARING IS NOW PACKED.
Slide the drum/hub on the spindle while you hold the outer bearing in the race as it goes on the spindle. Some put the drum/hub on without the outer bearing and then put the outer bearing in. Torque the inner nut to the spec in the book, install the washer and the outer nut and torque it and bend the tab.