The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Mike

Pages: [1]
1
Hey F Bill,

I will take some pics and dimensions when I replace the weld yoke on the driveshaft.� My weld yoke is so worn out the universal joint bearing cups are loose in the yoke you don't even need to press them in, they actually spin in the yoke ears.

Spicer, Neapco, and Rockford driveline all sell a new weld yoke, I just need to cut off the existing weld yoke through the existing weld and preserve as much of the original length as possible and get it square.

I have a used rusty driveshaft coming that hopefully is in better shape so if I totally mess my original up I have a backup.� I have a Omix-Ada shaft in now but it has just a bit of wobble on the splines with the splined yoke and I get a irritating vibration from it....even when phased correctly....

It might be a few weeks but I will post some info....cripes new driveshafts are like $400......weld yoke is like $50.....

Mike


Quote
I had an idea nobody would have a cut off shaft to measure....I guess you could drill a small hole to measure one but in any case it would mean destruction of a good shaft.

If you end up with pictures and dimensions needed to retube a driveshaft it would make a good FAQ post for the tech section.

2
Nevermind, I just picked up a used rear driveshaft and will be cutting off the worn weld yoke on my existing one to weld on a new yoke.  I will report back on the actual tube wall thickness for info purposes......

3
Just a real quick question...does anyone know the wall thickness of a stock rear prop shaft tube?� I know the OD is 1.25 but I need to know if the wall thickness is .120 or .188.....

Thanks,
Mike

4
Walck's finally has repo radiator shrouds for my 3A �:) ...been looking on ebay and around town for almost 5 years......just ordered one and I will install probably after the summer....

http://walcks4wd.com/radiator-shroud-side-mount-1950-1964-cj3a-cj3b.html?inf_contact_key=765f484b58607d93e15a24758d8707c395bcabee542c53d842f4917c18127a68

Mike

Pages: [1]