The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bayo500

Pages: [1] 2 3 ... 6
1
PAST EVENTS: / Jeep swap Meeting QLD
« on: October 15, 2013, 11:57:51 PM »
18th 19th and 20th Oct at  Canungra Show Grounds  Qld

2
PAST EVENTS: / Re: Emu Gully swap meet
« on: December 04, 2010, 09:38:33 PM »
 :'( Washed out, heavy rain, mud, maybe next year...

3
PAST EVENTS: / Emu Gully swap meet
« on: November 25, 2010, 10:18:39 PM »
3 - 5 December 2010,  Helidon Spa, Queensland, Australia.

Too far?  I'll keep the beers cold till you get there...

Should be some good jeep photos, I'll post them later.

4
"Original"-- Technical Questions, Answers, Observations / Re: No fuses ?
« on: November 18, 2010, 12:34:23 AM »
Thanks, I'll go with a hidden fusable link.

5
"Original"-- Technical Questions, Answers, Observations / No fuses ?
« on: November 11, 2010, 06:09:14 AM »
Hi, I'm rewiring my cj3a using a wiring diagram off the previous site. My question is the breaker on the end of the h/l switch, is that all the system needs ?  (I'm keeping it at 6 volt) Thanks...

6
Thanks Larry, i just bought one online, Steve.

7
I tried to fix the engine sump 3 times, leaking from the spot welds, once i had it off i filled it with kero and watched it slowly drip out along the bash plate, ended up getting a nos original -  put a new timing seal and gasket as well, best thing i ever did now i have no leaks at all from the engine.

8
That is one nice looking Jeep...

9
Floats on top, thats interesting, your right there was a lovely molassis 1/4 " thick.

10
Timing cover first, yes makes sense, as for sequence one gently in each corner to hold it up then around lightly till i get to around that 15 lb by hand, no air tools, hey anyone know why the oil pick up is on a hinge set-up?

11
Hi, any traps I should know about when replacing the engine pan gasket,plus the timing seal and gasket.

Would you fit the pan first or the timing cover?

Any sealant needed on the crank when I fit the pulley?

Thanks Steve in Queensland


Oh..and happy new year




12
Yeah, I'll ball peen them flat, well spotted...

13
OK, thanks guys, the kero test before i fit is a great idea, I'll sit it overnight.

Only numbers i can see are a 3 stamped ether side of the front near the timing cover area, the block casting is 11 28 �C lh rear

14


Hi again
Cleaned out the sump pan...
I always thought it was leaking between the pan guard and the pan and when I cleaned inside I found epoxy on the spot welds so I was right, the epoxy has finally cracked letting it drip out along the plate.
What do you think brazing, welding or more epoxy -  or maybe some sort of liquid metal.
Apparently the spot welds on engine sumps and fuel tanks have been a problem for many years, they seem to seep...
Steve in OZ.

15
Thanks Bob.

Pages: [1] 2 3 ... 6