The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - CJTHREEA

Pages: [1]
1
Hello.

I'm trying the get an old Willys running and trying to take things step by step.

After finding out the engine isnt frozen I need to get it to turn over.

I have a ballast resistor in the set up and lots of wiring suggestions do not include the ballast resistor.

I found an old wiring suggestion for a tractor and it seems to work.

But I just want to open this up to forum to see what everyone thinks.

I might have a bad coil - but I can't be 100% sure.

I left out the Alt for now.


2
I am fixing an old Willys - I'm sure most of you can understand that I'm not 100% sure of what parts should stay and which parts should go.

Is there are good way to identify my distributor - and whether or not it has been converted to 12V or not?

Here are some pictures:

Can anyone help?


3
Thank you Hawk!

I'm thinking mine are getting around 120/130 as well.

Is starting position towards drivers side or passenger side?

I have a 2A but it has a 3A windshield so I figured it more appropriate to post here.

After looking at the size of the arms and blades I had the wrong ones too as I've seen the 3A windshields blades are 9" - just not sure if my arms are wrong too - I'll have to look for a model number or something on them.

4
Does anyone know what the range of motion degrees should be?

My wiper motors are wiping through at least 120 degrees of motion...

Granted I have M131 motors but I understand these should work .... :o

Pages: [1]