Messages

1

Your CJ-3A Project / Re: 50 CJ3A "Nuthin' Fancy"

« on: September 06, 2018, 08:29:49 AM »

Just read through this tread. May I say you do amazing work!

And thank you for saving an old crusty from the scrap heap.

On those rust pock marks there is a Devcon product that you can use as a bondo that when dry is hard as steel.

Carry on and great work.

toolman_ar

2

Your CJ-3A Project / Re: Too rusty to save?

« on: September 19, 2015, 11:12:49 PM »

I would like to thank you for saving an old crusty tub, and showing people what can be completed. Even if you started out as a nob, with little sheet metal experience.

Great job!!

toolman_ar

3

Your CJ-3A Project / Re: Found a flat fender trailer,

« on: September 13, 2015, 03:57:25 PM »

That is a fine looking trailer.

Any chance you could snap a few more pictures of it?

I need something like that.

toolman_ar

4

Once You've Joined / Re: New member from Alabama

« on: September 12, 2015, 12:07:48 AM »

Thank you both.

I have enjoyed jeeps my whole life.

Just wish I had room and funds to collect one of each style.

My 49 is the never finished project.

Have plans for disk breaks and maybe a special front and rear end.

toolman_ar

5

Once You've Joined / New member from Alabama

« on: September 11, 2015, 12:22:28 AM »

Hello from Alabama.

When I was a kid I watched Army movies with my Dad and Brother. I always liked the look of the little Jeep.

At age 14 I purchased my first CJ3A...

The sickness is still with me, I am now 48 years old.

Two weeks ago I just purchased a 1946 CJ2a, or parts of one.

Thought I would joint up with like-minded pepole and it's nice to find I am not alone with my affinity for these old crusty Jeeps.

toolman_ar