The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Thorholt

Pages: [1]
1
Well I set the tub down on the frame today and it hit the top of the transmission before the mounts hit the frame, Just as I was starting to @#*! at it I raised it up on the hoist to look from underneath and when standing behind and looking at the transmission from the rear I could see that the clutch bellcrank shaft angled up from the frame to the transmission upon closer inspection I could see that the transmission crossmember had taken a hard hit at sometime and was bent up raising the transmission into the tub, I lowered the trans down to its proper position and all is good :)
The transfercase shift levers are spot on with the tub hole as is the transmission shifter hole, the clutch hole is good but the brake pedal hole is too high, another reported the same on his new 2A tub over on that forum also.
More to do tomorrow and I will take some pictures of it, there might be a problem with the throttle hole also, it seems to far to one side but I will need to look close at that also.

2
I got it uncrated and I was pleasantly surprised, the quality is good, needs about a hour of body work  time on the exterior and it will be ready to paint, The tool box lid is fixed, I do have a problem with the fuel tank, the mounting strap brackets are not there at all, the tank also hits the center transmission tunnel before the drain hole in the floor lines up, could be the tank also, it is a repo, I will measure more tomorrow. It also is missing the parking brake spring bracket down under.
Going to set it on the frame tomorrow and see how the rest goes.

3
Well I can probably add to this thread in a few days, I just unloaded my 3a tub but it is going on a 2a frame, I am reusing my hood, fenders, grill and tailgate so we should see how it fits with original parts also but the fenders and grill and hood are 2a stuff, I went with the 3a tub because I just wanted a little more belly room in my jeep, The build date on it is November of 2014 so it should be the latest, More to come.

Pages: [1]