6
« on: January 17, 2015, 08:28:18 AM »
Hi!
My name is Matt and it's currently 2F outside. The woodstove is cooking away, and it's warm inside.
When I was young my father had an old jeep that wasn't running and I remember crawling all over it. Other than the color, hard top, and radio that's about all I remember of it. That and my father said it was just like an old Army Jeep. Now it's time for me to get a jeep and crawl all over my own. Only I'll get to take apart this one too. [smiley=grin.gif]
So now comes the question of which model? That I'm not sure of. Luckily have a while to decide as I have a pretty long Honey Do List to work down including buying the wife a new car. I'd like to keep it as simple as possible and I figure that keeps me below the mid 70s.
Most of my wrenching has been limited to newer vehicles. Only my first car had a carb, but I've been bitten by the old outboard bug and run a couple 60s Evinrudes. There's something incredibly satisfying about taking something that's old and not running and then bringing it back to a well performing piece of machinery.
I've been through points ignitions and simple carbs. I've also pulled and repaired engines. I'm pretty sure with some guidance I can step up to something a bit more complicated. The hardest task was the ignitions as I couldn't find anybody who remembered how to work on them. I finally pulled one side apart and found they were pretty simple and only looked intimidating.
My main worry is parts availability as I remember being told the reason why the jeep wasn't running was he couldn't find a water pump for it. Maybe parts availability wasn't the same back in the 70s when I think the jeep was parked or there was an engine swap to something odd ball.
I'd hate to have something like worn out clutch linkage or something permanently park a jeep in my garage.
Well, hello again!
Matt