The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ChrisD

Pages: [1]
1
Thanks Scoutpilot. I found some at Mike's Carburetor.

2
I am rebuilding my WO Carter Carburetor. I am using a master kit. I just striped out the little brass screw that keeps the throttle valve on the shaft. I have the old screws but the instructions says to make sure and use a new one. Any ideas on where to get the proper screw?

3
Took the manifolds to my local machine shop. They had to drill out the holes where they bolt together and then re-surfaced it flat.

4
John, thanks - I did not know about the thick washer. I will loosen the bolts and see if I can bolt up to the engine. I will probably be visiting the machine shop this week to get it planed. 

5
Guys, I have new intake and exhaust manifolds that I am trying to install on my 1950 CJ3A. The manifolds will not align flat to the block once I bolt them together. I have already cracked one intake manifold because I did not check it before bolting it up.

Is there a trick I am missing??

Thanks,
Chris

6
Guys, thanks

I am going to the store to get me a dead blow hammer, shims, plastic wedges, and kroll.

Sounds like I need to get more aggressive with it. I will let you know how it goes this weekend.

7
I started stripping down the engine last weekend. I am following the procedure in the manual. Everything was going well until I got to removing the head. I can't seem to get the head to separate from the block. The manual recommends installing hooks into the spark plug holes to asset with lifting.

Right now I have the head under tension and in am soaking the studs with penetrating oil daily hopping it will finally separate.

Any by run into this before? Suggestions? I searched but did not find any threads.

8
Guys, thanks, that answers my questions. I did have the bearing in backwards and did not have the snap ring in place. Also explans why the pics of assemblied transmission have the wire on end.

I am going reassemble it this weekend and see how it goes.

Thanks again.

9
Attached is a pic with some text. I think I am simply miss understanding. I tried searching "T90", Bearing Adaptor Plate", "Main Shaft" and other key words but I have not found any info. The t90 rebuilt sheet on this site has been very helpful and it makes a comment about the "Large hole" adaptor plate vs. the "Small Hole" adaptor plate but does not provide much detail.

Any help is very appricated. Thanks.

10
What is the deal with the rear bearing adapter? I bought a full rebuid let from kaiser and it came with a rear bearing adapter plate with an interior hole of 1.75". My stock bearing adaptor has a interior hole of 1.81". I can't get the new one installed because it interferes with the bearing spacer. The old one does not keep the shaft from sliding out because the bearing is not an interference fit with the bearing adaptor. I can't find any info on this. Any help?

11
Once You've Joined / Hello from Texas
« on: December 10, 2013, 01:01:23 PM »
My son (14) and I just bought a 1950 CJ3a. We live in the Houston TX area and are planning are refurbishment. This is our first jeep and our first project together.

This sight has a ton of good information. Thank you to the administrators and others that make this site possible.

Pages: [1]