The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Kenny_Kustom

Pages: [1] 2 3 ... 5
1
Pull the pedals..

2
"Original"-- Technical Questions, Answers, Observations / Re: Axles
« on: April 25, 2013, 07:06:29 PM »
The rear 44 is a good one. Esp if it has a posi.
bigger brakes are good too...
All depends on how much work you want to do. You are not going to break the stock axles.

3
Quote
Snow shares a lot of characteristics with mud, so I guess they will work pretty good. I hope someone will weigh in with experience though.


Snow and mud are the same. But, ice is where the difference lies. Unless the tires have a good amount of siping, a great snow tire will suck on ice.

4
I'm running 31x9.5x15 super swampers.






5
How would one find out?

6
So... Where is it supposed to come through the firewall ?

Right beside my hole, where that spot has been patched ?

7
Not what I wanted to hear.  >:(

Mine has a rod through the firewall, down to a linkage that runs on top of the trans, over to another lever that pushes on the starter.





8
Could someone post a pic of how the foot starter rod is supposed to attach to the starter/linkage?

9
The nut plates are there.
I have some body bolts that will fit.

10
I have ordered the correct rad from walcks.
I guess I will have a good used 2a rad for sale!

11
I guess it gets down to what you want to match.

I ordered the correct fan shroud, as the other was home made.

So, do I send back the correct shroud? Or keep the shroud, and order the correct $500 rad.

I ordered the rad. I am trying to bring it back to as stock as I can.
With a few drivability mods.

13
Mine is a 51. My rad looks like the top, but my engine looks like the bottom. ( although, my air cleaner matches the top)

So, which is which?

The shroud i got doesnt fit.

The brackets on the bottom of my crossmember were added. There is also holes on the grill for the rad to mount to..

My rad only mounted on the bottom and the strut rod to the firewall


This old jeep thing is so confusing.... Working on my yj's and tj's were much easier !!  :P

14
I just got mine..

Very nice piece... Too bad someone went and put a 2A rad in my 3A >:( >:( >:( >:( >:(


15
"Original"-- Technical Questions, Answers, Observations / Re: Pedals
« on: March 26, 2013, 12:13:49 PM »
Quote
Pretty sure it goes below to seal up the pedal holes when you don't have your foot on the pedal..but lots of jeeps are completely missing all that stuff, mine included.


Mine were on top, but I figured they should go under. It would also soften the release of the clutch pedal. So, the pedal wont slam into the tub when you release the clutch.

Pages: [1] 2 3 ... 5