The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - captnjody

Pages: [1]
1
"Original"-- Technical Questions, Answers, Observations / Winch mount
« on: November 08, 2016, 09:07:42 PM »
Anyone have a good schematic and dimensions for a 3A winch mount for a Ramsey 200-r winch they could possibly email me?
Search didn't turn up anything.
I have my original Ramsey dmx200-r pto winch that was on my 3A, but have misplaced all my mounting bracket during the restoration, so I'm gonna have to fab a complete new one.
Thanks in advance.
Dave
Cptnjody@gmail.com

2
Make it easy on yourself, find a brake adjustment wrench. The adjustment studs can be a pain without a slotted wrench. i have bought several on Ebay, and it sure makes life alot easier.

3
I just went through the same thing. Either your PO was over greasing the wheel bearings, or your axle seals are bad. My seals were bad, the ones right at the backside of the wheel bearings at the end of the axle tube.

4
Try specialty tires of America. They have the ndt's, but also carry current aggressive
tread patterns as used by the military.

5
send me your email address..i will send you photos and measurements of the bracket I manufactured. It looks very factory, and is simple to build. i also run a declo alternator on my willys.

cptnjody@gmail.com

6
Does anyone have a NAPA other auto parts store part number for the rear
axle inner oil seal..cj3a, Dana 44, its the seal that's just inboard of the wheel
bearing..I really hate to have to order one of the Chinese cheap ones from KW or Walcks..have had terrible luck with those in the past, and
I sprung a leak, and after disassembly have found that the seal failed, pulled it and it has no part number on it..any help is appreciated, and I'm hoping to get it back together quickly.
thanks,
David

Pages: [1]