The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gsitts

Pages: [1]
1
To anyone who has the tiger top installed on a cj3a tub I need the height from the fender wells to the inside of the top where the roll bar would be and the interior width at the same spot. You guys probably have me figured out... I'm going to build a roll bar so I can install seatbelts and keep my wife happy. I'll be getting the top later . If someone can help I'll do a drawing and post it for future users. Thanks
Gordon

2
Hi, I'm in the middle of rewiring my new tub and am doing it wire by wire I've done this many times and I build electrical panels for a living so it not that hard for me.  For those who might be so inclined here are a  couple of tips. 1) make a copy of your dwg and mark each wire with a highliter as you put it in. 2) get a good crimping tool and use it properly. In my business I see a lot of wire not crimped correctly. Correctly means A) Stripped properly not nicked of cut up with a knife. B) Stripped the proper length to have the wire protruding slightly from the crimp. C) Insulation in the cup end but not in the crimp area. D) Not crimped until the wire is cut through. And finally After crimping pull on the wire to see how you did.
I hope this is helpful
Gordon

3
Rambling, Malarky, Rants, Etc... / Re: New member introductions thread...
« on: November 15, 2011, 09:15:04 PM »
Hi everyone I'm Gordon  and I live in Breaux Bridge La. I have been a gearhead all my life (I'm 65) and have always had a project or two around somewhere. I was able to get hold of my Grandfathers 1946 cj2a after watching it from afar for 20 years. I remember riding in this jeep when I was 5 yrs old so I just had to have it. I am restoring it as a Cj3a because I need the leg room being 6'1" tall. It was in pretty rough shape when I started on it last year. I pulled and rebuilt the motor and temporarily reassembled it to find out what else it needed and found the drive train in good shape so I pulled the body and ordered the new one. While it was coming in I stripped and sandblasted the frame, Fabricated about 1/3 of it over again,painted it and replaced the brakes and brake lines. I then painted the body,fenders tailgate windshield and a new grill and am just finished assembling this and about 1/3 of the way  rewiring so far. The Jeep guys like Walcks and Kaiser willys love me. I'm hoping to finish this as a driver this winter. By driver I mean I like 12v, alternators, solex carbs. new geared starters etc. I hope this doesn't give anyone heartburn. I just want it to look like about a 1949 cj3a when I'm done and start when I want to go. I've had 22 4x4's many of them jeeps. I'm not an expert but I'll try to help anyone if I can.
Thanks
Gordon

Pages: [1]