The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dtgolder

Pages: [1]
1
Your CJ-3A Project / Back in the Saddle
« on: March 12, 2025, 11:15:03 AM »
Just saying hi to everyone (again)--recently pulled my 52 CJ3a out of storage, and wanted to rejoin the forum (I see my profile was created in 2011--has it really been that long?)

Regardless, happy to be back.

d

2
Thoughts from other cars:

Pilot bearing for first motion shaft (sorry if some of my terminology may be Brit car based) but did have a pilot bearing issue that did that, along with possibly the release bearing/fork rattling.

Pressure plate and clutch disk also sound like possible culprits (Jag granny's had that kind of noise and it is often poorly staked rivets)

Stuff like that is often really tough to pin down

3
Ok this is going to sound weird, but soak the rusted threads in coca cola (no kidding). I've heard quite a few stories from folks who swear by this technique...worth a try...

4
I'd avoid adding silicone as a flush to an existing system. If you don't start with a new system you won't be able to flush out all traces of the old fluid. That will eventually "puddle" and that local concentration of conventional fluid will concentrate any remaining water in the system, and you will end up with localized rust spots.

So...flush with conventional fluid (beat choice) or replace with all new parts (lines, cylinders, etc...the WHOLE system) and use silicone (good choice for those doing a full restoration).

Don't ask me how I know... :-[

5
Agreed. Sounds like a needle / seat / float that's not working properly

6
Try http://www.speedbleeder.com/

(sorry just typed a long reply and lost it when I switched windows...darn iPad)

Anyway have had great successs with these things along with the tubing and a bottle.

Mushy brake pedal=air in the lines or soft/need to be replaced seals.

Also, when I need to change shoes I always bleed at the same time. I figure the fluid is old enough then to warrant a flush (and I feel safer adhering to this practice)

7
"Original"-- Technical Questions, Answers, Observations / Re: wire smoke
« on: December 10, 2011, 12:41:10 PM »
Sounds like you may have some Lucas wiring in your jeep?  ;D

http://www.spritespot.com/phpBB3/viewtopic.php?f=22&t=208&p=925&hilit=Smoke#p925

8
Rambling, Malarky, Rants, Etc... / Re: STUCK MOTOR - I'M STUCK
« on: December 20, 2011, 09:42:00 PM »
Ok, I have NOT tried this stuff:

http://www.metalrescue.com/consumer.aspx

But saw it on tv and it looks promising, and on their site they have a video testimonial from a guy who used it to free a seized engine...

Might be worth a try?

Pages: [1]