The CJ3A Page CJ3B.info

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mark103

Pages: [1]
1
Thanks for all the help guys, I thought red silicone was a bad choice to, but it's high temperature. Do you think the white Teflon stuff Permatex makes would stand the heat? I bought some of that to, but was afraid to put in on because of the heat.
What do you all recommend?
Thanks again
Mark

2
Thanks Carl, I'm getting ready to head out to my man cave and do a do over.
Do you have any information on the speedi sleeve for the front pulley?
Thanks for the help
Mark

3
Thanks for getting back so quick. I'll have to do that tomorrow. Looks like they would have made them longer :(
Thanks
Mark

4
I was out in the garage today getting my engine ready for the head. I cleaned all the head bolts, and applied a little red glue sealer, and put them back in with jam nuts and tightened them with a snug fit. When everything was cleaned up and I put the head on, the studs were to short. I could only get half a nut full with threads. :o It's been 2 years since I have worked on her, but I've always snugged studs down when I replace them. Do I need to get longer ones, or just turn these out 3/8 of an inch. Looks like the more threads you have in the block the stronger the head bolts would be? My head bolts are 3-3/8 inches long, has anyone ever replaced these with 3-7/8 studs?
What kind of sealer is supposed to be used, I had some permatex red silicone, and use that. They didn't have silicone back in the day, does anyone know what they used when our girls were new?
I also need a speedy sleeve for my front crank pulley, it seems I've read on the board where some one did that. If you would tell what size and where I can get one I be much obliged.
It seems all I have is a lot of needs and a lot of questions, don't mean to be a bother.
See ya
Mark

Pages: [1]