Messages

1

Chassis, brakes and suspension. / Re: CJ3B REAR 9" to 11" upgrade

« on: October 14, 2025, 10:41:58 AM »

Thanks for the confirmation!

Will make sure that I replicate the builds then on the rear.

Thanks!

Jorge

2

Chassis, brakes and suspension. / Re: CJ3B REAR 9" to 11" upgrade

« on: October 13, 2025, 03:48:46 PM »

Hello Rus!

The pic in the attached link you sent with the green Jeep and Warn hub is precisely my Jeep, front passenger side...  that is when I did the front upgrade.

My question is (not sure if I was clear) which one on the pic in this thread today is the Left and Right rear...  nos sure if the star for the self adjuster goes to front or rear of the Jeep on what side, unless both sides are installed the same way. two similar left, two similar right).

Thanks for your time!

Jorge

3

Chassis, brakes and suspension. / CJ3B REAR 9" to 11" upgrade

« on: October 13, 2025, 12:22:56 PM »

Hello Al!

Didi the 11" drum upgrade to my CJ3B a couple of years ago, and it works beautifully.

Found another set of backing plates, and will work on the rear now...  my question is, in the image below, which would be rear left and right?

http://www.the-jeep-guy.com/BRAKE%20KIT%20DRUM.JPG

Thanks!

4

"Original"-- Technical Questions, Answers, Observations / Re: My 3B won't hold idle and dies when "hot".

« on: October 26, 2020, 01:52:27 PM »

F-134, Carter YF...  all original, no mods.

5

"Original"-- Technical Questions, Answers, Observations / My 3B won't hold idle and dies when "hot".

« on: October 26, 2020, 11:29:26 AM »

Hello Gents!

I have noticed during my last 2 rides on my 3b that the same, during hot weather and riding it after 2 hours, when I go into neutral and stop in a stop sign o stop light, it shuts down.

I can start it once again, run it normally (no fails/sputters), but it wont hold the idle when stopped.  After it cools down, all is normal once again and will idle at any stop. 

Any suggestions?  Thanks!

Jorge