Messages

1

Your CJ-3B Project / Side entry step width and height

« on: October 17, 2022, 05:21:22 PM »

Hi all, does anyone have the approximate "stick out" from the side sheet of the body and the approx height of the side entry steps for a 3B from the ground? 


Thanks,

Brett.

2

"Original"-- Technical Questions, Answers, Observations / Re: transmission tunnel cover

« on: August 26, 2022, 10:04:16 AM »

Thank you, I will check out Harry.

B

3

"Original"-- Technical Questions, Answers, Observations / Re: transmission tunnel cover

« on: August 25, 2022, 10:39:02 AM »

Chuck W, they don't list a cover similar to the one that has the wrap down part at the throttle rod.  If indeed that is the one the picture is wrong.


B

4

"Original"-- Technical Questions, Answers, Observations / transmission tunnel cover

« on: August 24, 2022, 10:34:46 AM »

Hi all,

I am in need of a transmission tunnel cover, mine is so badly rusted I can not salvage it. Does anyone have a source?

Thanks,

1954 cj3b

Brett.

5

BODY and trim / floor pan measurement

« on: March 18, 2022, 10:23:25 AM »

Does anyone have the measurement from the front of the rear floor riser to the toe angle of the floor board.  I set up my riser and am getting some variation on the measurement, wondering if my riser is not square??  Seems to be too far back on the right side "wheel well lip is forward of where it should be"


Thanks,

B

6

BODY and trim / Re: Outside body width and tailgate opening dimensions

« on: March 08, 2022, 11:15:44 AM »

Thanks Fellas, I will get busy untwisting and getting it back into shape.

B

7

BODY and trim / Outside body width and tailgate opening dimensions

« on: March 07, 2022, 03:35:50 PM »

Hi All,

I am trying to work with a 54 3B that is very soft/twisted and somewhat nonexistent.  Can anyone verify that the outer body width dimension is 57 inches and the tailgate opening frame is 36 inches wide?

Thanks,

B

8

Buy, Sell, Trade / Kelly 300 hardtop for 3B

« on: January 15, 2020, 04:05:32 PM »

Hi Guys,

Does anyone have a lead on a rear hatch door for a Kelly 300 rear hatch door for a 3B?  My top is complete with the exception of the rear hatch.  I know there is a possibility I may have to make one.


Thanks,

Brett.