My Willys 3A and 3B Community
Your Projects => Your CJ-3B Project => Topic started by: Chuck W. on September 26, 2022, 03:47:02 PM
-
Today I finally installed the top back onto Wilson-Wilson. I had been putting it off, afraid I'd scratch the paint, but I am about over that. Once you put the first scratch on a new paint job, you don't worry as much anymore :)
(http://www.surfacezero.com/g503/data/500/20220926_140956.jpg)
(http://www.surfacezero.com/g503/data/500/20220926_140855.jpg)
(http://www.surfacezero.com/g503/data/500/20220926_140932.jpg)
-
Looks good!
-
Is there a pic I'm not seeing???
-
this forum is crazy, you will probably have to log out to see the post, wish they would fix it.
-
Looks great!
-
Is that a BesTop?
-
yes. I think it may be the original top that was sold with the jeep.
-
I have since learned that White Manufacturing became the approved manufacturer of tops for dealers in 1962, and apparently Bestop never became a Kaiser supplier, only later in the AMC history, so my top is not original.
-
I noticed a few details that make your top stand out. The back corners and the raised hump in the middle of the top surface where the bow is. Look at Lawrence Wade's white BesTop, where he states it's from 1985, and notice the similarities.
https://cj3b.info/Owners/Wade.html
I bought a BesTop for my 3B, probably around '79-'80. I didn't have the wrap around windows in the back.
-
I wish I had more history on the top, I am sure now that it's newer than the jeep. I notice that the new Bestop Tiger top and Supertop for the CJ3B does not have the wrap around side windows. I've been looking for photos of mid-60's Bestops with no luck. BTW, the side curtains don't roll up, they roll to the rear and are secured to the top bow with a strap, the wrap around windows stay in position!
On the subject of tops, here's what it looked like the day I bought it. I figured the top was trash and would need to be replaced.
(http://www.surfacezero.com/g503/data/500/102_1445.JPG)
It was extremely dirty and the isinglass appeared to be very yellowed, but the vinyl was still soft, all the stitching looked good and there were no tears or rips.
Following suggestions of people on the internet, especially boat top people, I carefully cleaned it with warm soapy water and a microfiber cloth and rubbed the vinyl with a heavy coat of Armorall. Then I used Pledge furniture polish to clean and polish the isinglass. I was told that the Pledge would add the needed oil back into the glass, and it seems to have worked! Not perfect, but much better than before.
(http://www.surfacezero.com/g503/data/500/20220926_140915.jpg)
(http://www.surfacezero.com/g503/data/500/20220926_1409321.jpg)
I routinely give the vinyl a coat of Armorall and the isinglass a cleaning with Pledge. I think more of the yellowing has cleared up every time I use the Pledge.
-
Very nice. I have one as well and contemplating installing on my CJ3B but I don't want to add the buttons. I like the strap look of other tops
-
Looks like your restoration worked very well. We had a Kayline Top in the 60's and Dad used Johnsons Paste wax to keep the Vinyl clear. I am sure he did that because that is what they used in the Army National Guard where dad was a Helio mechanic and they used the paste wax on the Plexiglass windows and bubbles.