My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: ChrisD on December 22, 2015, 07:38:38 PM

Title: WO Carter - Where do I get the little Brass Screws
Post by: ChrisD on December 22, 2015, 07:38:38 PM
I am rebuilding my WO Carter Carburetor. I am using a master kit. I just striped out the little brass screw that keeps the throttle valve on the shaft. I have the old screws but the instructions says to make sure and use a new one. Any ideas on where to get the proper screw?
Title: Re: WO Carter - Where do I get the little Brass Screws
Post by: scoutpilot on December 22, 2015, 08:27:56 PM
[size=12]If you can probably find them at Fastenal, but be prepared. You may have to buy 100 just to get one. If all else fails I can send you a couple.[/size][/b]
Title: Re: WO Carter - Where do I get the little Brass Screws
Post by: ChrisD on December 22, 2015, 10:33:58 PM
Thanks Scoutpilot. I found some at Mike's Carburetor.