My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Kirkski on September 17, 2014, 08:40:57 AM

Title: Transfer case mount
Post by: Kirkski on September 17, 2014, 08:40:57 AM: I am trying to get the transfer case mount off of my crossmember before I have the frame sandblasted and painted and was going to attempt to reuse it. I have tried a hammer to get the thing off. Is it just stuck with rust, or is there something else I don't know?

I am sure this question is rudimentary at best, please bear with me.

Kirk
Title: Re: Transfer case mount
Post by: Tumbleweed on September 17, 2014, 09:19:13 AM: The round mount on the right is welded to the cross member. You can take out the rubber mount and also the metal spun insert. When you buy a new mount it will come with the bolt, rubber mount's, spun insert, and nut.

Hope this helps.
Title: Re: Transfer case mount
Post by: athawk11 on September 17, 2014, 01:24:25 PM: Quote
The round mount on the right is welded to the cross member. You can take out the rubber mount and also the metal spun insert. When you buy a new mount it will come with the bolt, rubber mount's, spun insert, and nut.

Hope this helps.

X2 !ï¿½ ï¿½[smiley=thumbsup.gif]