My Willys 3A and 3B Community
3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: macrisel on June 15, 2014, 11:12:54 PM
-
I need some expert opinions on the teeth on my input shaft.� Are these teeth bad and need replacing or am I being too picky?
(http://i785.photobucket.com/albums/yy138/macrisel/5AD1B6DE-BF75-4476-A720-608852F1512B_zpskakmqj31.jpg)
(http://i785.photobucket.com/albums/yy138/macrisel/BC270C34-0F66-4D3D-83BC-BB6799A1C345_zpshdgwbadz.jpg)
Also, I had a little bit of pitting on the shaft.� It is in front of the bearing and the felt seal and I'm not sure if it is a big deal or not.� It is pretty hard to see in this photo.....
(http://i785.photobucket.com/albums/yy138/macrisel/324A2981-38BA-4103-B495-42BA9424679A_zps4aztpiaz.jpg)
One of my roller bearings looked like it had gotten caught between some gears...
(http://i785.photobucket.com/albums/yy138/macrisel/250B2009-CA25-4479-BA96-D63B424FA926_zpse1szrhdp.jpg)
My cluster gear looks worn, but according to Rick's guide I can clean it up with a file and re-use it...
(http://i785.photobucket.com/albums/yy138/macrisel/43F2B89A-2CCA-40CF-BD2D-F71AA1E4FB32_zpsblac6cgm.jpg)
Finally, a little glamour shot of the parts and pieces all cleaned up and organized..
(http://i785.photobucket.com/albums/yy138/macrisel/61AAE606-9881-4FFE-B581-ABDC84F0AD40_zpsphnxifie.jpg)
-
The pitting won't hurt anything but how is the race where the needle bearings go? If it is not pitted use it.