My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Jesse on April 14, 2014, 07:54:28 PM

Title: Difference in L and F head blocks?
Post by: Jesse on April 14, 2014, 07:54:28 PM
Hey guys,

Just doing a little keyboard wrenching tonight, and I was wondering if anyone could point out the real differences between an L and F head jeep block. Did the F head blocks still have the places for the old valves blocked off? I know they casted them without intake ports on the drivers' side. What other changes were made? Couldn't you just put an F head on an L engine?

If you could, it seems like more people would go for it so maybe it isn't possible...

-Jesse
Title: Re: Difference in L and F head blocks?
Post by: johnrb3b on April 15, 2014, 01:31:16 PM
Too many differences.
Pushrod guides for the intake valves in the head.
Manifolds
I don't know if the head bolts are in all the same places. Probably not.
Probably lots more I don't know about.
Title: Re: Difference in L and F head blocks?
Post by: Jesse on April 15, 2014, 01:41:09 PM
Hmm right I was thinking about the head bolts as well. Didn't think about the pushrod guides.

-Jesse
Title: Re: Difference in L and F head blocks?
Post by: Lee on April 15, 2014, 08:35:01 PM
Head bolts are in the same places, I recommend studying the gaskets before installing one, LOL, I installed a F head gasket in an L many years ago by mistake, results are NO compression and lots of bad language ;D

Lee ;)