My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: ZekeD on March 29, 2014, 02:31:08 PM

Title: Torque values
Post by: ZekeD on March 29, 2014, 02:31:08 PM
Is there a place where the torque values are listed for the L engine?  I tried searching the forum but didn't fine anything.

Specifically is there a number for the crankshaft pulley nut?

Thanks

Zeke in Oregon
Title: Re: Torque values
Post by: 1955CJ-5 on March 29, 2014, 02:57:40 PM
The book says to install the pulley and tighten the nut!! Pretty informative....

There must be a number somewhere....2a site maybe?
Title: Re: Torque values
Post by: ZekeD on March 29, 2014, 04:03:36 PM
Yep!   I read the book, got me to the same place ;D

Zeke
Title: Re: Torque values
Post by: Mike S on March 29, 2014, 10:50:44 PM
In the Willys service manual you will find the torque specifications for engine and chassis on page 275 - table U55.

I think the crankshafft pulley nut is like 180 - 200 lbs./ft.? Not sure however.
Title: Re: Torque values
Post by: Ryan_M on March 29, 2014, 11:15:40 PM
This does not have the specific answer you are looking for but it does have some other pretty handy torque specs:

http://www.cj-2a.com/techtips/specs/torques.html