My Willys 3A and 3B Community
3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: ZekeD on February 03, 2014, 10:42:14 AM
-
I want to go to dual master cyl on my '49 CJ3 and I have the tub off of the chassis, and the rolling stock is almost finished. I can route the lines, but is there interference with the tub caused by the larger MC?
Zeke. ( making progress )
-
Check out page 8 of GarageGnome's project. He shows a pic of an installed dual MC that clears the tub.
http://www.cj3apage.com/cgi-bin/yabb2/YaBB.pl?num=1364006201/118#118
-
Yep, as Ryan posted, R&Ps kits works great. I did Herms on my 53, but if I was to do it again, I would use R&Ps kit. Much easier to install. There is a link a few pages back in that thread to purchase the kit.