My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: ZekeD on November 20, 2013, 12:13:32 PM

Title: Oil pan crush washer
Post by: ZekeD on November 20, 2013, 12:13:32 PM
I have never seen a crush washer that was not solid (copper).  The oil pan washer from Walcks is solid on one side but wraps around a fiber washer with a gap on the other.   Which side goes toward the pan?   Does it matter?

Thanks
Zeke
Title: Re: Oil pan crush washer
Post by: 1955CJ-5 on November 20, 2013, 05:49:57 PM
I can't imagine which way it goes....you ordered two, right? ;D

The more I think about it the more it seems that it doesn't matter...

otherwise it would have come with instructions :D
Title: Re: Oil pan crush washer
Post by: ZekeD on November 20, 2013, 08:18:32 PM
I could twist it into a M�bius loop and then it would have only one side, and there couldn't be a question.....but I bet it would still leak!  :o

I should have bought two, but then................
Title: Re: Oil pan crush washer
Post by: 1955CJ-5 on November 20, 2013, 08:36:27 PM
Well, just be sure to thread it through the Worm Hole, then you could be in both dimensions at once..

And what's another little drip, after all?