My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Shalka04 on November 03, 2013, 12:56:56 AM

Title: Carb. V gasket is it needed?
Post by: Shalka04 on November 03, 2013, 12:56:56 AM
So i'm going to swap out my Solex piece of crap tomorrow for my recently returned & Rebuilt Carter.  :-)  Life will be good again.

Here's the issue / problem.  The Carter is slightly taller then the Solaex, and as a result my airhorn tends to rub on the underside of the hood, when the carter is installed.
If I go with a regular gasket instead of the special V shaped one to go between the carb and the manifold I will avoid further rubbing.

How critical is that special  gasket with the V built into it?

Thanks for your thoughts,

-John
Title: Re: Carb. V gasket is it needed?
Post by: Carls_jeep on November 03, 2013, 04:52:57 PM
If you have an L134 flat head engine with original manifolds and air cleaner crossover pipe you should have about a half an inch between the hood and the crossover pipe. Mine does and I am using the thick original gasket with my carb.