My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Buildinghippy on May 15, 2013, 06:23:48 PM

Title: Transmission crossmember and pedal dimensions
Post by: Buildinghippy on May 15, 2013, 06:23:48 PM: I have searched this page and the 2a site and I could not find what I was looking for. Tryin to find to location of both, so that I can check that my crossmember is in the right place and to figure out where the pedals go. Looking for the dimensions as pulled off the rearmost crossmember. Thanks in advance for all the help.
Title: Re: Transmission crossmember and pedal dimensions
Post by: athawk11 on May 15, 2013, 07:05:55 PM: BH,

Are you looking to position the Tranny/TC support?ï¿½ If so, I found it easier and more accurate to measure from the center of the rear leaf spring mount, forward, to the Tranny/TC cross member mounting holes.ï¿½ They are at: 20 1/2" and 23" to center.

If I misunderstand what you are trying to measure, post back and I run out and do it again.

Tim
Title: Re: Transmission crossmember and pedal dimensions
Post by: Buildinghippy on May 15, 2013, 07:36:27 PM: Tim thank you for the help, that was just what I needed.