My Willys 3A and 3B Community

3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: Macgraham on May 13, 2013, 11:37:15 AM

Title: stencil
Post by: Macgraham on May 13, 2013, 11:37:15 AM
Can someone educate me on the Willys hood stencil?  I don't have the stencil yet but it looks like it  could be difficult to use the flat stencil on the raised letters. Has anyone any info? Thanks, Mac :-/ :-/ :-/
Title: Re: stencil
Post by: garage gnome on May 13, 2013, 11:41:47 AM
I never have good luck with stencils, so I hand paint on the Willys. Takes a small brush and steady hand. For the 4WD in the tailgate, I get a decal from here:

http://www.pixeldecals.com/shop/index.php?route=product/category&path=37

(http://i748.photobucket.com/albums/xx125/willyscjmj/1953%20Willys%20CJ3A%20Jeep%20Restoration/100_7062.jpg) (http://s748.photobucket.com/user/willyscjmj/media/1953%20Willys%20CJ3A%20Jeep%20Restoration/100_7062.jpg.html)
Title: Re: stencil
Post by: bretto on May 14, 2013, 06:51:42 AM
It would be tedious, but I would mask off each letter with tape in order to get crisp straight lines.
I don't know exactly, but wasn't it stock that the letter stamp was the same color as the body?  I don't know the history there to say, I have a M38, they had no badging other than the tool box front.
Title: Re: stencil
Post by: ZekeD on May 14, 2013, 10:37:39 AM
How about a printer's "brayer" ?  It should hit the high places and not the hood.

Just thimkin'  :) :)

ZD
Title: Re: stencil
Post by: macrisel on May 14, 2013, 11:01:25 AM
Here is what I did for my emboss on the hood using a base/clear...

1.  Primer the entire hood.
2.  Paint/clear the emboss white.
3.  Scuff the area to remove any tape lines
4.  Paint/clear the entire hood, including the emboss, with the body color.  In my case it was Nomandy Blue.
5.  Tape off the letters on the emboss and CAREFULLY wet sand the blue off the top of the letters until you get down to the white.
6.  Scuff the entire hood again and put 2-3 coats of clear over everything.

This makes some very nice, clean lines and has everything protected under several layers of clear.  There are more photos and descriptions under my build thread "PROGRESS" under the "Stock Jeep Project" section.

Good luck!  Its a lot of work but very well worth it.
Title: Re: stencil
Post by: 1oldracer on May 14, 2013, 10:34:47 PM
And don't forget surface preparation.  Its such a treat to watch a nice clean painted letter bubble up and dribble away - don't ask how I know!