My Willys 3A and 3B Community
3A, 3B, DJ Technical Knowledge Base => "Original"-- Technical Questions, Answers, Observations => Topic started by: bretto on September 12, 2012, 06:01:43 PM
-
Was the heat shield plate made from aluminum or steel? �I have some steel but thought that would rust in no time given the shields environment. �If aluminum, I'll have to come up with some some. �Anyone have an idea on where to buy a small amount? �I don't use aluminum to justify buying a lot of it.
Brett
-
Steel.
http://www.thecj2apage.com/forums/heat-shield-master-cylinder_topic4669.html
(http://www.cj-2a.com/parts/brakes/heat_shield/heat_shield-1l.jpg)
Larry
-
Thanks Larry.
Any good recommendations for the fiber insulation material?
Brett
-
Midwest military has them with thE fiber for a reasonable price, I just bought one, it works great.
-
Ya, there are a lot of reasonable priced parts out there but I'd get nickeled and dimed to death if I went that route for everything. I have to make some things to same money. I like doing it to if I can. :)
So far tonight I made the plate and the 2 arms.
Brett
-
I know the fiber board is not the best thing but this is better than what was there which was nothing.
I'm going to paint it OD also.
(http://i1201.photobucket.com/albums/bb356/1brale/M38%20restore/IMG_0503-8493.jpg)
(http://i1201.photobucket.com/albums/bb356/1brale/M38%20restore/IMG_0503-8494.jpg)
(http://i1201.photobucket.com/albums/bb356/1brale/M38%20restore/IMG_0503-8496.jpg)
(http://i1201.photobucket.com/albums/bb356/1brale/M38%20restore/IMG_0503-8497.jpg)
-
Oh and I have to give credit to Sean Collins from the CJ-2A page for the drawing!
Thanks Sean.
Brett
-
Brett,
Looks real nice. What's it going to take for you to make another one for your friend in Colorado?
Tim